368, "/R= DISABLE READ MULTIPLE\nSyntax: /R={0|1}[,0|1][,0|1][,0|1]\nThis option controls read multiple on a 'per drive' basis. Read multiple is enabled by default when /M is used. Write multiple is not affected.\n\"0\" enables read multiple for the drive; \"1\" disables read multiple for the drive. Settings for multiple drives are separated by commas as shown.\n\n\n/W= DISABLE WRITE MULTIPLE\nSyntax: /W={0|1}[,0|1][,0|1][,0|1]\nThis option controls write multiple on a 'per drive' basis. Write multiple is enabled by default when /M is used. Read multiple is not affected.\n\"0\" enables write multiple for the drive; \"1\" disables write multiple for the drive. Settings for multiple drives are separated by commas as shown."
369, "Selecting A Hard Disk Drive To Install"
370, "To select a drive to partition and format, first select the controller tab that contains your hard drive and then select your drive from the tab.\n\nIf your drive is attached to a traditional hard drive controller, select the \"Onboard Controller\" tab.\nIf your drive is attached to an add on controller card, select the \"Ultra-ATA Controller\" tab.\nIf you are installing a SCSI drive select the \"Other\" tab.\n\nOnce you have selected the drive to install, press \"Next\" to continue."
371, "Disk Manager has detected that the drive is jumpered with an alternate capacity jumper (Capacity Clip). This instructs the drive to report a smaller size than it actually is.\n\nThis setting is usually used as a solution to certain BIOS \"hanging\" problems. However, some operating systems do not work correctly with this setting.\n\nDisk Manager can solve this problem by issuing a \"Set Max\" command to the drive allowing you to remove the capacity clip. You will be remided to remove the capacity clip jumper setting after completing this installation."
372, "Important: You must shut down and remove the alternate capacity jumper setting before an operating system will work correctly with this drive. To view the correct jumper settings, click \"Done\", select the \"Hard Disk Information\" option on the main menu and select \"View Hard Drive Jumper Settings\". "
373, "Windows &Me"
374, "Issue Set Max command. You will be asked to remove the alternate capacity jumper. (Recommended)"
375, "I want the drive to remain jumpered with the Alternate Capacity Jumper. (Not Recommended)"
376, "Disk Manager is now copying all files from the Boot Drive."
377, "The partitions that have been created are now formatted.\n\nTo install an Operating System, remove the diskette from drive A: and reboot. When the blue Ontrack Banner appears press the SPACEBAR to install an OS from diskette or press \"C\" to install an OS from CD-ROM."
